Planet Networking & Communication SGS-6340-24T4S Command Manual page 952

Usage Guide:
The system holds up to 20 commands the user entered, the user can use the UP/DOWN key or their equivalent
(ctrl+p and ctrl+n) to access the command history.
Example:
Switch#show history
enable
config
interface ethernet 1/3
enable
dir
show ftp
65.13 show history all-users
Command:
show history all-users [detail]
Function:
Show the recent command history of all users.
Parameter:
[detail] shows user name of the executing command. IP address of the user will be shown when logging in the
executing command through Telnet or SSH.
Command Mode:
Admin and configuration mode
Usage Guide:
This command is used to show the recent command history of all users, including time, logging type, executing
command, etc.
Notice: The user can only check the command history of other users whose purview should not be higher than
oneself.
Example:
Switch(config)#show history all-users detail
65-400