Planet Networking & Communication SGS-6340-24T4S Command Manual page 753

Parameters:
<value> upper limit of the number of dynamic ARP of the port, ranging from 1 to 4096.
Default Settings:
The number limitation function of dynamic ARP on the port is disabled.
Command Mode:
Port mode.
Usage Guide:
When configuring the max number of dynamic ARP allowed by the port, if the number of dynamically learnt ARP on
the port is already larger than the max number to be set, the extra dynamic ARP will be deleted. TRUNK ports do not
supports this function.
Examples:
Enable the number limitation function of dynamic ARP in port 1/2 mode, the max number to be set is 20
Switch(config)#interface ethernet 1/2
Switch(Config-If-Ethernet1/2)# switchport arp dynamic maximum 20
Disable the number limitation function of dynamic ARP in port 1/2 mode
Switch(Config-If-Ethernet1/2)#no switchport arp dynamic maximum
42.14 switchport mac-address dynamic maximum
Command:
switchport mac-address dynamic maximum <value>
no switchport mac-address dynamic maximum
Function:
Set the max number of dynamic MAC address allowed by the port, and, at the same time, enable the number
limitation function of dynamic MAC address on the port; "no switchport mac-address dynamic maximum"
command is used to disable the number limitation function of dynamic MAC address on the port.
Parameters:
<value> upper limit of the number of dynamic MAC address of the port, ranging from 1 to 4096.
Default Settings:
The number limitation function of dynamic MAC address on the port is disabled.
42-201