Planet Networking & Communication SGS-6340-24T4S Command Manual page 374

Parameters:
bits_per_second: The committed information rate – CIR (Committed Information Rate), in Kbps, ranging from 1 to
10000000;
normal_burst_bytes: The committed burst size – CBS (Committed Burst Size), in byte, ranging from 1 to 1000000.
When the configured CBS value exceeds the max limit of the chip, configure the hardware with max number
supported by the chip without any CLI prompt; maximum_burst_bytes: The peak burst size – PBS (Peak Burst
Size), in byte, ranging from 1 to 10000000. When the configured PBS value exceeds the max limit of the chip,
configure the hardware with max number supported by the chip without any CLI prompt. Notice: this configuration
only exists in dual bucket mode;
pir peak_rate_bps: The peak information rate – PIR (Peak Information Rate), in kbps, ranging from 1 to 10000000.
Without configuring PIR, the Police works in the single rate dual bucket mode; otherwise in the dual rate dual bucket
mode. Notice: this configuration only exists in dual bucket mode;
violate-action: The actions to take when the PIR is exceeded, which means the messages are red,
default as drop;
conform-action: The action to take when the CIR is not exceeded, which means the messages are green, the
default as transmit;
exceed-action: The actions to take when the CIR is exceeded but PIR isn't, which means the messages are yellow,
the default as drop.
ACTION include:
drop/transmit: Drop/transmit the packets
set-dscp-transmit sets DSCP, it is valid to IPv4 and IPv6 packets, only set-dscp-transmit or set-prec-transmit can be
selected.
set-prec-transmit sets TOS, only set-prec-transmit or set-dscp-transmit can be selected
set-internal-priority sets the internal priority of the packets
set-Drop-Precedence sets the drop precedence of the packets
set-cos-transmit sets the CoS value of the L2 packets
Default:
No policy action; the default action of conform-action is transmit, while that of exceed-action and violate-action are
both drop.
Command mode:
Policy class map configuration Mode
20-136
the