Planet Networking & Communication SGS-6340-24T4S Command Manual page 752

Function:
Display the number of dynamic ND of corresponding port and VLAN.
Parameters:
<vlan-id> is play the specified vlan ID. <portName> is the name of layer-2 port.
Command Mode:
Admin and Configuration Mode.
Usage Guide:
Use this command to display the number of dynamic ND of corresponding port and VLAN.
Examples:
Display the number of dynamic ND of the port and VLAN which are configured with number limitation function of ND.
Switch(config)# show nd-dynamic count interface ethernet 1/3
Port MaxCount
-----------------------------------------------------------------------------------------------------
Ethernet1/3
-----------------------------------------------------------------------------------------------------
Switch(config)# show nd-dynamic count vlan 1
Vlan MaxCount
-----------------------------------------------------------------------------------------------------
1
-----------------------------------------------------------------------------------------------------
42.13 switchport arp dynamic maximum
Command:
switchport arp dynamic maximum <value>
no switchport arp dynamic maximum
Function:
Set the max number of dynamic ARP allowed by the port, and, at the same time, enable the number limitation
function of dynamic ARP on the port; "no switchport arp dynamic maximum" command is used to disable the
number limitation function of dynamic ARP on the port.
CurrentCount
5 1
CurrentCount
55 15
42-200