Planet Networking & Communication SGS-6340-24T4S Command Manual page 902

Default:
The default value is 0.
Usage Guide:
When sample packet is sent to the CPU, it is recommended not to assign high priority for the packet so that regular
receiving and sending of other protocol packet will not be interfered. The higher the priority value is set, the higher its
priority will be.
Example:
Configure the priority when sFlow receives packet from the hardware at global mode.
switch (config)#sflow priority 1
58.8 sflow rate
Command:
sflow rate { input <input-rate> | output <output-rate >}
no sflow rate [input | output]
Function:
Configure the sample rate of the sFlow hardware sampling. The "no" form of this command deletes the sampling rate
value.
Parameter:
<input-rate> is the rate of ingress group sampling, the valid range is 1000~16383500.
<output-rate> is the rate of egress group sampling, the valid range is 1000~16383500.
Command Mode:
Port Mode.
Default:
No default value.
Usage Guide:
The traffic sampling will not be performed if the sampling rate is not configured on the port. And if the ingress group
sampling rate is set to 10000, this indicates there will be one group be sampled every 10000 ingress groups.
58-350