Planet Networking & Communication SGS-6340-24T4S Command Manual page 429

Default:
The default managing distance of RIP is 120.
Command Mode:
Router mode and address-family mode
Usage Guide:
In case there are routes from two different routing protocols to the same destination, the managing distance is then
used for selecting routes. The less the managing distance of the route protocol is, the more reliable will be the route
acquired from the protocol.
Example:
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# distance 8 10.0.0.0/8 mylist
24.9 distribute-list
Command:
distribute-list {<access-list-number | access-list-name> |prefix<prefix-list-name>} {in|out} [<ifname>]
no distribute-list {<access-list-number| access-list-name> |prefix<prefix-list-name>} {in|out} [<ifname>]
Function:
This command uses access-list or prefix-list to filter the route update packets sent and received. The "no
distribute-list {<access-list-number| access-list-name> |prefix<prefix-list-name>} {in|out} [<ifname>]"
command cancels this route filter function.
Parameter:
<access-list-number |access-list-name> is the name or access-list number to be applied. <prefix-list-name> is
the name of the prefix-list to be applied.
<ifname> specifies the name of interface to be applied with route filtering.
Default:
The function in default situation is disabled.
Command Mode:
Router mode and address-family mode
24-34