Planet Networking & Communication SGS-6340-24T4S Command Manual page 889

Usage Guide:
There is no sequence requirement for the master and slave port configuration in a group, but the protective VLANs
must be configured before the member ports. Each group has only one master port, if the master port exists, then the
configuration fail.
Example:
Configure the master port of ULPP group.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp group 20 master
55.29 ulpp group slave
Command:
ulpp group <integer> slave
no ulpp group <integer> slave
Function:
Configure the slave port of ULPP group, the no command deletes the slave port.
Parameter:
<integer> is the ID of ULPP group, the range from 1 to 48.
Default:
There is no slave port configured by default.
Command mode:
Port mode.
Usage Guide:
There is no sequence requirement for the master and slave port configuration in a group, but the protective VLANs
must be configured before the member ports. Each group has only one slave port, if the slave port exists, then the
configuration is fail.
Example:
Configure the slave port of ULPP group.
Switch(config)# interface ethernet 1/2
Switch(config-If-Ethernet1/2)# ulpp group 20 slave
55-337