Planet Networking & Communication SGS-6340-24T4S Command Manual page 542

30.1.24 netbios-node-type
Command:
netbios-node-type {b-node | h-node | m-node | p-node | <type-number>}
no netbios-node-type
Function:
Sets the node type for the specified port; the "no netbios-node-type" command cancels the setting.
Parameters:
b-node stands for broadcasting node, h-node for hybrid node that broadcasts after point-to-point communication;
m-node for hybrid node to communicate in point-to-point after broadcast; p-node for point-to-point node;
<type-number> is the node type in Hex from 0 to FF.
Default:
No client node type is specified by default.
Command Mode:
DHCP Address Pool Mode
Usage Guide:
If client node type is to be specified, it is recommended to set the client node type to h-node that broadcasts after
point-to-point communication.
Example:
Setting the node type for client of pool 1 to broadcasting node.
Switch(dhcp-1-config)#netbios-node-type b-node
30.1.25 network-address
Command:
network-address <network-number> [<mask> | <prefix-length>]
no network-address
Function:
Sets the scope for assignment for addresses in the pool; the "no network-address" command cancels the setting.
30-34