Planet Networking & Communication SGS-6340-24T4S Command Manual page 887

55.26 ulpp flush enable mac-vlan
Command:
ulpp flush enable mac-vlan
Function:
Enable receiving the flush packets of mac-vlan type.
Parameter:
None.
Default:
Disable.
Command mode:
Port mode.
Usage Guide:
If enabling this function, configure the interface to receive the flush packets handled mac-vlan type and delete the
dynamic unicast mac according to vlan information in the packets.
Example:
Enable receiving the flush packets deleted by mac-vlan of port.
Switch(config)#interface e1/2
Switch(config-if-ethernet1/2)#ulpp flush enable mac-vlan
55.27 ulpp group
Command:
ulpp group <integer>
no ulpp group <integer>
Function:
Create a ULPP group. If this group exists, then enter the configuration mode of ULPP group. The no command
deletes a ULPP group.
55-335