Planet Networking & Communication SGS-6340-24T4S Command Manual page 651

Example:
Switch (config)#interface ethernet1/4
Switch (Config-If-Ethernet1/4)#ip multicast source-control access-group 5000
Switch (Config-If-Ethernet1/4)#
Switch(router-msdp)#default-rpf-peer 10.0.0.1 rp-policy 10
37.1.9 multicast destination-control
Command:
multicast destination-control
no multicast destination-control
Function:
Configure to globally enable multicast destination control, the NO command is to recover and disable the
multicast destination control globally.
Parameters:
None.
Default:
Disabled.
Command Mode:
Global Configuration Mode.
Usage Guide:
Only after globally enabling the multicast destination control, the other destination control configuration can take
effect; the destination access list can be applied to ports, VLAN-MAC and SIP. After configuring this command,
IGMP-SNOOPING and IGMP will match according to the rules mentioned above when they try to add ports after
receiving IGMP-REPORT.
Example:
switch(config)# multicast destination-control
37-99