Planet Networking & Communication SGS-6340-24T4S Command Manual page 844

53.1.9 savi ipv6 check source ip-address mac-address
Command:
savi ipv6 check source [ip-address mac-address | ip-address | mac-address]
no savi ipv6 check source
Function:
Enable the control authentication function for the packets of the port, no command disables this function.
Parameter:
None.
Command Mode:
Port Mode.
Default:
Disable the control filtering function of the port.
Usage Guide:
The global SAVI function must be enabled before configuring this command.
Example:
Enable the control filtering function of the packets on port ethernet1/1.
Switch(config)#interface ethernet1/1
Switch(config-if-ethernet1/1)# savi ipv6 check source ip-address mac-address
53.1.10 savi ipv6 {dhcp-only | slaac-only | dhcp-slaac} enable
Command:
savi ipv6 {dhcp-only | slaac-only | dhcp-slaac} enable
no savi ipv6 {dhcp-only | slaac-only | dhcp-slaac} enable
Function:
Enable SAVI application scene function, no command disables the function.
53-292