Planet Networking & Communication SGS-6340-24T4S Command Manual page 694

Parameters:
<num> is the No. of access-list, 100-299; <protocol> is the No. of upper-layer protocol of ip, 0-255; <sIpAddr> is
the source IP address, the format is dotted decimal notation; <sMask > is the reverse mask of source IP, the format
is dotted decimal notation; <dIpAddr> is the destination IP address, the format is dotted decimal notation; <dMask>
is the reverse mask of destination IP, the format is dotted decimal notation, attentive position o, ignored
position1;<igmp-type>,the type of igmp, 0-15; <icmp-type>, the type of icmp, 0-255;<icmp-code>, protocol No. of
icmp, 0-255;<prec>, IP priority, 0-7; <tos>, to value, 0-15; <sPort>, source port No., 0-65535; <sPortMin>, the
down boundary of source port; <sPortMax>, the up boundary of source port; <dPortMin>, the down boundary of
destination port; <dPortMax>, the up boundary of destination port; <dPort>, destination port No., 0-65535;
<time-range-name>, the name of time-range.
Command Mode:
Global mode
Default:
No access-lists configured.
Usage Guide:
When the user assign specific <num> for the first time, ACL of the serial number is created, then the lists are added
into this ACL; the access list which marked 200-299 can configure not continual reverse mask of IP address.
<igmp-type> represent the type of IGMP packet, and usual values please refer to the following description:
17(0x11): IGMP QUERY packet
18(0x12): IGMP V1 REPORT packet
22(0x16): IGMP V2 REPORT packet
23(0x17): IGMP V2 LEAVE packet
34(0x22): IGMP V3 REPORT packet
19(0x13): DVMR packet
20(0x14): PIM V1 packet
Particular notice: The packet types included here are not the types excluding IP OPTION. Normally, IGMP packet
contains OPTION fields, and such configuration is of no use for this type of packet. If you want to configure the
packets containing OPTION, please directly use the manner where OFFSET is configured.
Examples:
Create the numeric extended access-list whose serial No. is 110. deny icmp packet to pass, and permit udp packet
with destination address 192. 168. 0. 1 and destination port 32 to pass.
Switch(config)#access-list 110 deny icmp any any-destination
Switch(config)#access-list 110 permit udp any host-destination 192.168.0.1 d-port 32
40-142