Planet Networking & Communication SGS-6340-24T4S Command Manual page 725

Command mode:
Global Mode and Port Mode.
Default:
802.1x function is not enabled in global mode by default; if 802.1x is enabled under Global Mode, 802.1x will not be
enabled for the ports by default.
Usage Guide:
The 802.1x authentication for the switch must be enabled first to enable 802.1x authentication for the respective
ports. If Spanning Tree or MAC binding is enabled on the port, or the port is a Trunk port or member of port
aggregation group, 802.1x function cannot be enabled for that port unless such conditions are removed.
Example:
Enabling the 802.1x function of the switch and enable 802.1x for port1/12.
Switch(config)#dot1x enable
Switch(config)#interface ethernet 1/12
Switch(Config-If-Ethernet1/12)#dot1x enable
41.8 dot1x ipv6 passthrough
Command:
dot1x ipv6 passthrough
no dot1x ipv6 passthrough
Function:
Enable IPv6 passthrough function on a switch port, only applicable when access control mode is userbased; the no
operation of this command will disable the function.
Command Mode:
Port Configuration Mode.
Default Settings:
IPv6 passthrough function is disabled on the switch by default.
Usage Guide:
The function can only be enabled when 802.1x function is enabled both globally and on the port, with userbased
being the control access mode. After it is enabled, users can send IPv6 messages without authentication.
41-173