Planet Networking & Communication SGS-6340-24T4S Command Manual page 443

24.26 offset-list
Command:
offset-list <access-list-number |access-list-name> {in|out} <number > [<ifname>]
no offset-list <access-list-number |access-list-name> {in|out} <number > [<ifname>]
Function:
Add an offset value to the metric value of the routes learnt by RIP. The "no offset-list <access-list-number
|access-list-name> {in|out} <number > [<ifname>]" command disables this function.
Parameter:
< access-list-number |access-list-name> is the access-list or name to be applied. <number > is the added offset
value, ranging between 0-16; <ifname> is the specific interface name
Default:
Default offset value is the metric value defined by the system.
Command Mode:
Router mode and address-family mode
Example:
Switch# config terminal
Switch(config)# router rip
Switch(config-router)# offset-list 1 in 5 vlan 1
Related Command:
access-list
24.27 passive-interface
Command:
passive-interface <ifname>
no passive-interface <ifname>
Function:
Set the RIP layer 3 switch blocks RIP broadcast on specified interface, on which the RIP data packets will only be
sent to layer 3 switches configured with neighbor.
24-48