Planet Networking & Communication SGS-6340-24T4S Command Manual page 231

OAM_local_link-fault
OAM_local_dying gasp
OAM_local_critical event
11.26 show ethernet-oam link-events configuration
Command:
show ethernet-oam link-events configuration [interface {ethernet | } <IFNAME>]
Function:
Show configuration of link events on specified or all ports with OAM enabled, including detection period and
threshold of the events and so on.
Parameters:
<IFNAME>, the port that the statistic information of OAM link events needs to be shown, the statistic information of
OAM link events for all ports will be shown if this parameter is not specified.
Command Mode:
Admin mode
Default:
N/A.
Usage Guide:
N/A.
Example:
Show configuration of link events on ethernet 1/1.
Switch#show ethernet-oam link-events configuration interface ethernet 1/1
Ethernet1/1 link-monitor configuration：
event
----------------------------------------------------------------------------------------------------
Err-symbol-Period
Err-frame-Period
Err-frame
Err-frame-second-summary
the reset of OAM function
The number of the local link-fault faults
The number of the local dying-gasp faults
The number of the local critical-event faults
high-threshold low-threshold
none 1
none 1
none 2
none 2
11-230
window(200ms)
2
10
5
600