Planet Networking & Communication SGS-6340-24T4S Command Manual page 739

Example:
Setting the re-authentication time to 1200 seconds.
Switch(config)#dot1x timeout re-authperiod 1200
41.26 dot1x timeout tx-period
Command:
dot1x timeout tx-period <seconds>
no dot1x timeout tx-period
Function:
Sets the interval for the supplicant to re-transmit EAP request/identity frame; the "no dot1x timeout tx-period"
command restores the default setting.
Parameters:
<seconds> is the interval for re-transmission of EAP request frames, in seconds; the valid range is 1 to 65535.
Command mode:
Global Mode.
Default:
The default value is 30 seconds.
Usage Guide:
Default value is recommended.
Example:
Setting the EAP request frame re-transmission interval to 1200 seconds.
Switch(config)#dot1x timeout tx-period 1200
41.27 dot1x unicast enable
Command:
dot1x unicast enable
no dot1x unicast enable
41-187