Planet Networking & Communication SGS-6340-24T4S Command Manual page 829

51.12 webportal nas-ip
Command:
webportal nas-ip <ip-address>
no webportal nas-ip
Function:
Configure IP source address for communicating between accessing device and portal server.
Parameter:
<ip-address>: IP source address for communicating between accessing device and portal server in dotted decimal
notation, it must be the legal unicast address.
Command Mode:
Global Mode.
Default:
Do not configure the specific IP source address, the communication between accessing device and portal server
uses the IP address of the sending interface.
Usage Guide:
The configured source address must be the local IP address, or else it maybe not process the packet communication
with portal server. It is recommended to use the loopback interface address as the source address to avoid the return
packet is unreachable when the physical interface is down, and nas-ip should be configured in web portal. The no
command deletes IP source address for communicating between accessing device and portal server.
Example:
Configure IP source address as 10.1.1.1 for communicating between accessing device and portal server.
switch(config)#webportal nas-ip 10.1.1.1
51.13 webportal redirect
Command:
webportal redirect <ip>
no webportal redirect
51-277