Planet Networking & Communication SGS-6340-24T4S Command Manual page 748

Parameters:
<value> upper limit of the number of dynamic ARP in the VLAN, ranging from 1 to 4096.
Default Settings:
The number limitation function of dynamic ARP in the VLAN is disabled.
Command Mode:
Interface Configuration Mode.
Usage Guide:
When configuring the max number of dynamic ARP allowed in the VLAN, if the number of dynamically learnt ARP in
the VLAN is already larger than the max number to be set, the extra dynamic ARP will be deleted.
Examples:
Enable the number limitation function of dynamic ARP in VLAN 1, the max number to be set is 50.
Switch(config)#interface ethernet
Switch(Config-if-Vlan1)# ip arp dynamic maximum 50
Disable the number limitation function of dynamic ARP in VLAN 1.
Switch(Config-if-Vlan1)#no ip arp dynamic maximum
42.8 ipv6 nd dynamic maximum
Command:
ipv6 nd dynamic maximum <value>
no ipv6 nd dynamic maximum
Function:
Set the max number of dynamic NEIGHBOR allowed in the VLAN, and, at the same time, enable the number
limitation function of dynamic NEIGHBOR in the VLAN; "no ipv6 nd dynamic maximum" command is used to
disable the number limitation function of dynamic NEIGHBOR in the VLAN.
Parameters:
<value> upper limit of the number of dynamic NEIGHBOR in the VLAN, ranging from 1 to 4096.
Default Settings:
The number limitation function of dynamic NEIGHBOR in the VLAN is disabled.
42-196