25.21 default-metric
Command:
default-metric <value>
no default-metric
Function:
The command set the default metric value of OSPF routing protocol; the "no default-metric" returns to the default
state.
Parameter:
<value>, metric value, ranging between 0~16777214.
Default:
Built-in, metric value auto translating.
Command Mode:
OSPF protocol mode
Usage Guide:
When the default metric value makes the metric value not compatible, the route introducing still goes through. If the
metric value can not be translated, the default value provides alternative option to carry the route introducing on. This
command will result in that all introduced route will use the same metric value. This command should be used
associating redistribute.
Example:
Switch#config terminal
Switch(config)#router ospf 100
Switch(config-router)#default-metric 100
25.22 distance
Command:
distance {<value>|ROUTEPARAMETER}
no distance ospf
Function:
Configure OSPF manage distance base on route type. The "no distance ospf" command restores the default value.
25-76