Planet Networking & Communication SGS-6340-24T4S Command Manual page 883

Parameter:
<vlan-list> specify the control VLAN list that receives the flush packets, such as: i; j-k. The number of VLANs in
Each character string can not exceed 100. The receiving control VLAN of the port can be added.
Default:
The default is VLAN 1.
Command mode:
Port mode.
Usage Guide:
Configure the receiving control VLAN for the port. This VLAN must correspond the existent VLAN, after it is
configured, this VLAN can't be deleted.
Example:
Configure the receiving control VLAN as 10.
Switch(config)# interface ethernet 1/1
Switch(config-If-Ethernet1/1)# ulpp control vlan 10
55.21 ulpp flush disable arp
Command:
ulpp flush disable arp
Function:
Disable receiving the flush packets of deleting ARP.
Parameter:
None.
Default:
By default, disable receiving the flush packets of deleting ARP.
Command mode:
Port mode.
55-331