Planet Networking & Communication SGS-6340-24T4S Command Manual page 670

Parameters:
<vlan-id>: the specific VLAN ID, the range from 1 to 4094.
<value>: the maximum query response time, unit is second, the range from 1 to 25, default value is 1.
Command Mode:
Global mode
Default:
Enable the function.
Usage Guide:
After enable vlan snooping in global mode, input this command to configure the maximum query response time of
the specific group.
Example:
Configure/cancel the specific-query-mrsp of vlan3 as 2s.
Swith(config)#ip igmp snooping vlan 3 specific-query-mrsp 2
Swith(config)#no ip igmp snooping vlan 3 specific-query-mrspt
37.2.21 ip igmp snooping vlan static-group
Command:
ip igmp snooping vlan <vlan-id> static-group <A.B.C.D> [source <A.B.C.D>] interface [ethernet |
port-channel] <IFNAME>
no ip igmp snooping vlan <vlan-id> static-group <A.B.C.D> [source <A.B.C.D>]interface [ethernet |
port-channel] <IFNAME>
Function:
Configure static-group on specified port of the VLAN. The no form of the command cancels this configuration.
Parameter:
vlan-id: ranging between <1-4094>
A.B.C.D: the address of group or source
ethernet: Name of Ethernet port
port-channel: Port aggregation
ifname: Name of interface
37-118