Planet Networking & Communication SGS-6340-24T4S Command Manual page 944

Parameter:
<ipv4-addr> is the IPv4 address of the host, <ipv6-addr> is the IPv6 address of the host; <local-number> is the
recording equipment of the host with a valid range of local0～local7, which is in accordance with the facility defined
in the RFC3164; <severity> is the severity threshold of the log information severity level. The rule of the log
information output is explained as follows: only those with a level equal to or higher than the threshold will be
outputted. For detailed description on the severity please refer to the operation manual.
Command Mode:
Global Mode
Default:
No log information output to the log host by default. The default recorder of the log host is the local0; the default
severity level is warnings.
Usage Guide:
Only when the log host is configured by the logging command, this command will be available. We can configure
many IPv4 and IPv6 log hosts.
Example 1:
Send the log information with a severity level equal to or higher than warning to the log server with an IPv4 address
of 100.100.100.5, and save to the log recording equipment local1.
Switch(config)# logging 100.100.100.5 facility local1 level warnings
Example 2:
Send the log information with a severity level equal to or higher than informational to the log server with an IPv6
address of 3ffe:506:1:2::3, and save to the log recording equipment local5.
Switch(config)# logging 3ffe:506:1:2::3 facility local1 level informational
65.5 logging executed-commands
Command:
logging executed-commands {enable | disable}
Function:
Enable or disable the logging executed-commands.
65-392