Planet Networking & Communication SGS-6340-24T4S Command Manual page 600

Function:
This command enables switch relay to support the option 38, the no form of this command disables it.
Parameters:
None.
Default:
Disable the relay option 38.
Command Mode:
Global configuration mode
Usage Guide:
Only after this command is configured, DHCPv6 relay agent can add option 38 in DHCPv6 request packets before
sending it to server or next relay agent. Make sure that DHCPv6 service has been enabled before execute this
command. The option 38 of switch relay is disabled by default.
Example:
Enable the switch relay to support option 38.
Switch(Config)#service dhcpv6
Switch(Config)#ipv6 dhcp relay subscriber-id option
34.1.8 ipv6 dhcp relay subscriber-id select delimiter
Command:
ipv6 dhcp relay subscriber-id select (sp | sv | pv | spv) delimiter WORD (delimiter WORD |)
no ipv6 dhcp relay subscriber-id select delimiter
Function:
Configures user configuration options to generate subscriber-id. The no form of this command restores to its original
default configuration, i.e. vlan name together with port name.
Parameters:
(sp | sv | pv | spv): a selection in combinations of slot, port and vlan, among which sp represents slot and port, sv
represents slot and vlan, pv represents port and vlan, and spv represents slot, port and vlan.
WORD: the delimiter between slot, port and vlan which ranges among (#|.|,|;|:|/|space). Note that there're two
delimiter WORDs here, of which the former is the delimiter between slot and port and the latter is the one between
port and vlan.
34-48