Planet Networking & Communication SGS-6340-24T4S Command Manual page 375

Usage Guide:
The CLI can support both singe bucket and dual bucket configuration, and determine which one to select by
checking whether PIR or PBS is configured. When configuring with CLI, after configuring CBS, if the action is directly
configured, the mode is single bucket dual color; if only PBS is configured, the mode is single rate dual bucket three
color; if PIR and PBS are configured, the mode is dual rate dual bucket three color. "set" and "policy"（policy
aggregate） are selected and have the same action in Policy Map, then the action selected by "policy" will cover the
action of "set".
Example:
In the policy class table configuration mode, set the CIR as 1000, CBS as 2000 and the action when CIR is not
exceeded as transmitting the messages after changing DSCP to 23, and the action triggered by exceeding CIR as
transmit without changing the messages.
Switch(config)#class-map cm
Switch(config-classmap-cm)#match cos 0
Switch(config-classmap-cm)#exit
Switch(config)#policy-map 1
Switch(config-policymap-1)#class cm
Switch(config-policymap-1-class-cm)#policy 1000 2000 conform-action set-dscp-transmit 23
20.15 policy aggregate
Command:
policy aggregate <aggregate-policy-name>
no policy aggregate <aggregate-policy-name>
Function:
Police Map reference aggregate policy, applies an aggregate policy to classified traffic; the no command deletes the
specified aggregate policy.
Parameters:
<aggregate-policy-name> is the policy set name.
Default:
No policy is configured by default.
Command mode:
Policy class map configuration Mode
20-137