Planet Networking & Communication SGS-6340-24T4S Command Manual page 392

Command Mode:
Class-map Mode
Usage Guide:
Only one match standard can be configured in a class map. When configuring the ACL match, permit rule is the
match option, it will apply Policy Map action. Deny rule is the excluding option, it does not apply Policy Map action. If
it has been configured other match rule, the operation is failure, but configuring the same match rule will cover the
previous.
Example:
Create a class-map named c1, and configure the class rule of the class-map to match packets with IP Precedence of
0.
Switch(config)#class-map c1
Switch(config-classmap-c1)#match ip precedence 0
Switch(config-classmap-c1)#exit
22.2 service-policy
Command:
service-policy <policy-map-name> in
no service-policy <policy-map-name> in
Function:
Bind the specified policy of flexible QinQ to the ingress of the port, the no command cancels the binding.
Parameters:
service-policy <policy-map-name>: The specified policy-map name of flexible QinQ.
Default:
No policy map is bound to port.
Command mode:
Port Mode.
Usage Guide:
Only one policy map can be bound to each port, the function takes effect after the policy map is bound to a port. If
s-vid needs to be modified, enable QinQ function on the corresponding port at first. At present, do not support the
configuration with add commend and delete command in policy.
22-154