Planet Networking & Communication SGS-6340-24T4S Command Manual page 731

Function:
Sets the maximum users allowed connect to the port; the "no dot1x max-user" command restores the default setting.
Parameters:
<number> is the maximum users allowed, the valid range is 1 to 256.
Command mode:
Port configuration Mode.
Default:
The default maximum user allowed is 1.
Usage Guide:
This command is available for ports using MAC-based access management, if MAC address authenticated exceeds
the number of allowed user, additional users will not be able to access the network.
Example:
Setting port 1/3 to allow 5 users.
Switch(Config-If-Ethernet1/3)#dot1x max-user macbased 5
41.16 dot1x max-user userbased
Command:
dot1x max-user userbased <number>
no dot1x max-user userbased
Function:
Set the upper limit of the number of users allowed access the specified port when using user-based access control
mode; the no command is used to reset the default value.
Parameters:
<number> the maximum number of users allowed to access the network, ranging from 1 to 1~256.
Command Mode:
Port Mode.
41-179