Planet Networking & Communication SGS-6340-24T4S Command Manual page 779

Usage Guide:
This command is used to specify the IPv4/IPv6 address and port number of the specified RADIUS server for switch
accounting, multiple command instances can be configured. The <port-number> parameter is used to specify
accounting port number, which must be the same as the specified accounting port in the RADIUS server; the default
port number is 1813. If this port number is set to 0, accounting port number will be generated at random and can
result in invalid configuration. This command can be used repeatedly to configure multiple RADIUS servers
communicating with the switch, the switch will send accounting packets to all the configured accounting servers, and
all the accounting servers can be backup servers for each other. If primary is specified, then the specified RADIUS
server will be the primary server. It only configures a RADIUS primary server whether the server use IPv4 address or
IPv6 address.
Example:
Sets the RADIUS accounting server of IPv6 address to 2004:1:2:3::2, as the primary server, with the accounting port
number as 3000.
Switch(config)#radius-server accounting host 2004:1:2:3::2 port 3000 primary
46.12 radius-server authentication host
Command:
radius-server authentication host {<ipv4-address> | <ipv6-address>} [port <port-number>] [key {0 | 7}
<string>] [primary] [access-mode {dot1x | telnet}]
no radius-server authentication host {<ipv4-address> | <ipv6-address>}
Function:
Specifies the IPv4 address or IPv6 address and listening port number, cipher key, whether be primary server or not
and access mode for the RADIUS server; the no command deletes the RADIUS authentication server.
Parameters:
<ipv4-address> | <ipv6-address> stands for the server IPv4/IPv6 address;
<port-number> for listening port number, from 0 to 65535, where 0 stands for non-authentication server usage;
<string> is the key string. If key option is set as 0, the key is not encrypted and its range should not exceed 64
characters, if key option is set as 7, the key is encrypted and its range should not exceed 64 characters;
primary for primary server. Multiple RADIUS Sever can be configured and would be available. RADIUS Server will
be searched by the configured order if primary is not configured, otherwise, the specified RADIUS server will be
used last.
[access-mode {dot1x|telnet}] designates the current RADIUS server only use 802.1x authentication or telnet
authentication, all services can use current RADIUS server by default.
46-227