Planet Networking & Communication SGS-6340-24T4S Command Manual page 770

Default:
3 seconds by default.
Usage Guide:
The command specifies the period the switch wait for the authentication through TACACS+ server. When connected
to the TACACS+, and after sent the authentication query data packet to the TACACS+ server, the switch waits for the
response. If no replay is received during specified period, the authentication is considered failed.
Example:
Configure the timeout timer of the tacacs+ server to 30 seconds.
Switch(config)#tacacs-server timeout 30
45.5 debug tacacs-server
Command:
debug tacacs-server
no debug tacacs-server
Function:
Open the debug message of the TACACS+; the "no debug tacacs-server" command closes the TACACS+
debugging messages.
Command Mode:
Admin Mode
Parameter:
None.
Usage Guide:
Enable the TACACS+ debugging messages to check the negotiation process of the TACACS+ protocol which can
help detecting the failure.
Example:
Enable the debugging messages of the TACACS+ protocol.
Switch#debug tacacs-server
45-218