Planet Networking & Communication SGS-6340-24T4S Command Manual page 671

Command Mode:
Global mode
Default:
No configuration by default.
Usage Guide:
When a group is a static while also a dynamic group, it should be taken as a static group. Deleting static group can
only be realized by the no form of the command.
Example:
Switch(config)#ip igmp snooping vlan 1 static-group 224.1.1.1 source 192.168.1.1 interface ethernet 1/1
37.2.22 ip igmp snooping vlan suppression-query-time
Command:
ip igmp snooping vlan <vlan-id> suppression-query-time <value>
no ip igmp snooping vlan <vlan-id> suppression-query-time
Function:
Configure the suppression query time. The "no ip igmp snooping vlan <vlan-id> suppression-query-time"
command restores to the default value.
Parameter:
vlan-id: VLAN ID, ranging between <1-4094>
value: ranging between<1-65535> seconds
Command Mode:
Global mode
Default:
255s
Usage Guide:
This command can only be configured on L2 general querier. The Suppression-query-time refers to the period of
suppression state in which the querier enters when receives query from the layer 3 IGMP in the segments.
37-119