Planet Networking & Communication SGS-6340-24T4S Command Manual page 710

Parameter:
<sIPv6Addr> is the source IPv6 address; <sPrefixlen> is the length of the IPv6 address prefix, the range is 1～128;
<dIPv6Addr> is the destination IPv6 address; <dPrefixlen> is the length of the IPv6 address prefix, the range is 1～
128; <igmp-type>, type of the IGMP; <icmp-type>, icmp type; <icmp-code>, icmp protocol number; <dscp>, IPv6
priority ,the range is 0 ～ 63; <flowlabel>, value of the flow label, the range is 0 ～ 1048575;
syn,ack,urg,rst,fin,psh,tcp label position; <sPort>, source port number, the range is 0～65535; <sPortMin>, the
down boundary of source port; <sPortMax>, the up boundary of source port; <dPort>, destination port number, the
range is 0～65535; <dPortMin>, the down boundary of destination port; <dPortMax>, the up boundary of destination
port. <next-header>, the IPv6 next-header. <time-range-name>, time range name.
Command Mode:
IPv6 nomenclature extended access control list mode
Default:
No access control list configured.
Example:
Create an extended access control list named udpFlow, denying the igmp packets while allowing udp packets with
destination address 2001:1:2:3::1 and destination port 32.
Switch(config)#ipv6 access-list extended udpFlow
Switch(Config-IPv6-Ext-Nacl-udpFlow)#deny igmp any any-destination
Switch(Config-IPv6-Ext-Nacl-udpFlow)#permit udp any-source host-destination 2001:1:2:3::1 dPort 32
40.21 permit | deny(ipv6 standard)
Command:
[no] {deny | permit} {{<sIPv6Prefix/sPrefixlen>} | any-source | {host-source <sIPv6Addr>}}
Function:
Create a standard nomenclature IPv6 access control rule; the no form of this command deletes the nomenclature
standard IPv6 access control rule.
Parameter:
<sIPv6Prefix> is the prefix of the source IPv6 address, <sPrefixlen> is the length of the IPv6 address prefix, the
valid range is 1~128. <sIPv6Addr> is the source IPv6 address.
40-158