Planet Networking & Communication SGS-6340-24T4S Command Manual page 485

Default:
Default retransmit interval is 5 seconds.
Command Mode:
Interface Configuration Mode.
Usage Guide:
When a layer 3 switch transmits LSA to its neighbor, it will maintain the link state announcements till confirm from the
object side is received. If the confirm packet is not received within the interval, the LSA will be retransmitted. The
retransmit interval must be larger than the time it takes to make a round between two layer 3 switches.
Example:
Configure the LSA retransmit interval of interface vlan 1 to 10 seconds.
Switch#config terminal
Switch(config)#interface vlan 1
Switch(Config-if-Vlan1)#ip ospf retransmit-interval 10
25.39 ip ospf transmit-delay
Command:
ip ospf [<ip-address>] transmit-delay <time>
no ip ospf [<ip-address>] transmit-delay
Function:
Set the transmit delay value of LSA transmitting; the "no ip ospf [<ip-address>] transmit-delay" restores the
default value.
Parameter:
<ip-address> is the interface IP address show in dotted decimal notation.
<time> is the transmit delay value of link state announcements between the interface and adjacent layer 3 switches,
shown in seconds ranging between 1～65535.
Default:
Default transmit delay value of link state announcements is 1 second.
Command Mode:
Interface Configuration Mode.
25-90