Verify The Drive Backplane - Oracle Netra SPARC S7-2 Service Manual

Verify the Drive Backplane

See:
"Returning a Server to Operation" on page 235
■
"Verify the Drive Backplane" on page 124
■
Related Information
"Detecting and Managing Faults" on page 25
■
"Returning a Server to Operation" on page 235
■
Verify the Drive Backplane
After you install the drive backplane, you can verify its functionality.
1. Access Oracle ILOM.
See "Log In to Oracle ILOM (Service)" on page
2. Reset the drive backplane.
-> set /SYS/DBP clear_fault_action=true
Are you sure you want to clear /SYS/DBP (y/n)? y
Set 'clear_fault_action' to 'true'
->
3. Verify that the drive backplane is not faulty, then return to this procedure.
See "Determine if the Drive Backplane Is Faulty" on page
4. Verify that the installed drives are recognized.
-> show /SYS/DBP
/SYS/DBP
Targets:
HDD0
HDD1
HDD2
...
->
Related Information
"Determine if the Drive Backplane Is Faulty" on page 118
■
"Detecting and Managing Faults" on page 25
■
124 Netra SPARC S7-2 Server Service Manual • February 2017
26.
118.