Verify The Drive Backplane - Oracle SPARC T8-1 Service Manual

a. Reconnect the auxiliary signal cable to the drive backplane (panel 3).
Reconnect the power cable to the drive backplane (panel 5).
b.
If present, reconnect the two optional NVMe cables to the storage drive
c.
backplane (panel 5).
Reconnect the two SAS cables to the drive backplane from the motherboard
d.
(panel 6).
4. Return the Server to
"Verify the Drive Backplane" on page
5.
Related Information
"Internal Component Locations" on page 14
■
"Remove the Drive Backplane" on page 147
■

Verify the Drive Backplane

1.
Use the Oracle ILOM show faulty command to verify that the fault has been
cleared.
See "Identify Faulted Components" on page 23
command.
2. Perform one of the following tasks based on your verification results:
If the previous steps did not clear the fault, see
■
Faults" on page 21
to diagnose component faults.
If the previous steps indicate that no faults have been detected, then the
■
component has been replaced successfully. No further action is required.
Related Information
"Remove the Drive Backplane" on page 147
■
"Install the Drive Backplane" on page 149
■
Operation.
151.
for more information on using the show faulty
for information about the tools and methods you can use
Verify the Drive Backplane
"Detecting and Managing
Servicing the Drive Backplane 151