Removing The Server From The Rack - Oracle Netra SPARC S7-2 Service Manual

Remove a Server From the 4-Post, 19-inch Rack
2. Attach an antistatic wrist strap.
When servicing or removing server components, attach an antistatic strap to your wrist and then
to a metal area on the chassis.
3. Remove the server.
See "Removing the Server From the Rack" on page
Related Information
"Disconnect Power Cords and Data Cables" on page 52
■
"Removing the Server From the Rack" on page 56
■
"Remove the Top Cover" on page 67
■
"Safety Information" on page 44
■

Removing the Server From the Rack

Before you can remove the top cover to access components inside of the server chassis, you
might have to remove the server from the rack.
"Remove a Server From the 4-Post, 19-inch Rack" on page 56
■
"Remove the Cable Management Arm" on page 58
■
"Remove a Server From the 2-Post, 19-inch Rack" on page 63
■
Related Information
"Disconnect Power Cords and Data Cables" on page 52
■
"Prevent ESD Damage" on page 55
■
Remove a Server From the 4-Post, 19-inch Rack
Caution -
dismount and carry the chassis.
The steps to remove the server from a 4-post, 19-inch rack depend on the type of server
mounting. Either the server is hard mounted with the hardmount rack kit, or the server is
mounted with a sliding rail kit.
56 Netra SPARC S7-2 Server Service Manual • February 2017
The server weighs approximately 21.5 kg (47.3 lbs). Two people are required to
56.