Verify A Sas Drive - Oracle Netra SPARC S7-2 Service Manual

Related Information
"Remove a SAS Drive" on page 89
■
"Verify a SAS Drive" on page 95
■
"SAS Drive Configuration" on page 86
■
"Preparing for Service" on page 43
■
"Returning a Server to Operation" on page 235
■

Verify a SAS Drive

After you install a SAS drive, you can verify its functionality.
Access Oracle ILOM.
1.
See "Log In to Oracle ILOM (Service)" on page
Check for the presence of the drive.
2.
-> show /SYS/DBP/HDDx/PRSNT
/SYS/DBP/HDD0/PRSNT
Targets:
Properties:
type = Entity Presence
ipmi_name = HDD0/PRSNT
class = Discrete Sensor
value = Present
alarm_status = cleared
->
where x is 0 to 7.
3. If you replaced a drive, verify that the drive location is no longer considered
faulty, then return to this procedure.
See "Locate a Faulty Drive" on page
4. If the OS was shut down, and the drive you installed was not the boot device,
boot the OS.
Depending on the function of the replaced drive, you might need to perform administrative
tasks to reinstall software before the server can boot. Refer to the OS documentation for more
information.
26.
87.
Verify a SAS Drive
Servicing SAS Drives 95