Verify Drive Backplane Functionality - Oracle SPARC T5-2 Service Manual

a. Install the top cover.
See "Replace the Top Cover" on page
b. Return the server to the normal operating position.
See "Return the Server to the Normal Operating Position" on page
Power on the server.
c.
See "Returning the Server to Operation" on page
Authorized service personnel might need to reprogram the product serial number on
Note -
the drive backplane. This number is used for service entitlement and warranty coverage. The
correct product serial number is located on a label on the front of the chassis.
Related Information
"Remove the Drive Backplane" on page 157
■
"Verify Drive Backplane Functionality" on page 161
■

Verify Drive Backplane Functionality

1.
Use the Oracle ILOM show faulty command to verify that the fault has been
cleared.
See "Check for Faults" on page 46
Perform one of the following tasks based on your verification results:
2.
If the previous steps did not clear the fault, see
■
for information about the tools and methods you can use to diagnose component faults.
If the previous steps indicate that no faults have been detected, then the component has been
■
replaced successfully. No further action is required.
Related Information
"Remove the Drive Backplane" on page 157
■
"Install the Drive Backplane" on page 159
■
169.
169.
for more information on using the show faulty command.
"Detecting and Managing Faults" on page 31
Verify Drive Backplane Functionality
170.
Servicing the Drive Backplane 161