Verify The Drive Backplane - Oracle netra X5-2 Service Manual

Verify the Drive Backplane

6. Complete these postrequisites in this order to finish the installation procedure.
"Returning the Server to Operation" on page 247
■
"Verify the Drive Backplane" on page 178
■
Related Information
"Remove the Drive Backplane" on page 173
■
"Verify the Drive Backplane" on page 178
■
"Drive Backplane Configuration" on page 171
■
"Preparing for Service" on page 61
■
"Returning the Server to Operation" on page 247
■
Verify the Drive Backplane
After you install the drive backplane, you can verify its functionality.
Access Oracle ILOM.
1.
See "Access the SP (Oracle ILOM)" on page
2. Reset the drive backplane.
-> set /SYS/DBP clear_fault_action=true
Are you sure you want to clear /SYS/DBP (y/n)? y
Set 'clear_fault_action' to 'true'
->
3. Verify that the drive backplane is no longer considered faulty, then return to this
procedure.
See "Determine if the Drive Backplane Is Faulty" on page
Verify that the installed drives are recognized.
4.
-> show /SYS/DBP
/SYS/DBP
Targets:
HDD0
HDD1
HDD2
...
->
Related Information
"Install the Drive Backplane" on page 176
■
178 Netra Server X5-2 Service Manual • October 2016
28.
172.