Verify A Pcie Card - Oracle Netra SPARC S7-2 Service Manual

6. Swing the retainer to its fully closed position.
If there is resistance, check the alignment of the PCIe card bracket and try again.
Do not force the card into the slot. Damage to the card or the server might occur.
Caution -
7. Repeat from
installing.
If you installed a PCIe card as part of another component's removal or
8.
installation procedure, return to that procedure.
See "Component Service Task Reference" on page
Complete these postrequisites in this order to finish the installation procedure.
9.
See:
"Returning a Server to Operation" on page 235
■
"Verify a PCIe Card" on page 177
■
Related Information
"Remove a PCIe Card" on page 174
■
"Verify a PCIe Card" on page 177
■
"PCIe Card Configurations" on page 170
■
"Preparing for Service" on page 43
■
"Returning a Server to Operation" on page 235
■

Verify a PCIe Card

After you install a PCIe card, you can verify its functionality.
1. Access Oracle ILOM.
See "Log In to Oracle ILOM (Service)" on page
Reset the PCIe card.
2.
-> set /SYS/MB/PCIEy clear_fault_action=true
Are you sure you want to clear /SYS/MB/PCIE1 (y/n)? y
Set 'clear_fault_action' to 'true'
Step 4 through Step 6 for additional PCIe cards that you are
47.
26.
Verify a PCIe Card
Servicing PCIe Cards 177