Verify Removal Of An Nvme Drive; Install An Nvme Drive - Oracle Netra SPARC S7-2 Service Manual

Verify Removal of an NVMe Drive

Related Information
"Install an NVMe Drive" on page 100
■
"Power On an NVMe Drive and Attach a Device Driver" on page 101
■
"Verify the Operation of an NVMe Storage Drive" on page 102
■
Verify Removal of an NVMe Drive
This task uses pcie13 as an example.
At the superuser prompt, type:
Note -
# hotplug list –lc
Connection State
------------------------------------------------------------------
pcie13
Related Information
"Unmount an NVMe Drive" on page 98
■
"Remove an NVMe Drive" on page 99
■
"Power On an NVMe Drive and Attach a Device Driver" on page 101
■
"Verify the Operation of an NVMe Storage Drive" on page 102
■

Install an NVMe Drive

The steps to install an NVMe drive are the same as the steps to install a SAS drive. For detailed
instructions, see
Note -
installing a replacement drive.
1. Follow safety and ESD precautions.
See "Prevent ESD Damage" on page
2. Remove the new drive from its packaging, and place the drive on an antistatic
mat.
100 Netra SPARC S7-2 Server Service Manual • February 2017
The state of the slot must be EMPTY.
Description Path
EMPTY PCIe-Native /pci@7a,0/pci8086,2f08@3/pci111d,80b5@4
"Install a SAS Drive" on page
After you remove an NVMe drive from the server, wait at least 10 seconds before
92.
55.