Install A Sas Drive - Oracle Netra SPARC S7-2 Service Manual

Install a SAS Drive

Related Information
"Locate a Faulty Drive" on page 87
■
"Install a SAS Drive" on page 92
■
"Preparing for Service" on page 43
■
"Returning a Server to Operation" on page 235
■
Install a SAS Drive
Installing a SAS drive is a hot-plug operation. You do not need to power off the server before
installing the drive. This procedure is the same for installing a drive filler.
1. Consider your first step.
■ If you are replacing a drive, remove the faulty or obsolete drive first, then
return to this procedure,
See
If you are installing a new or an additional drive, go to
■
If you are installing a drive as part of another component's service
■
procedure, go to
2. Review this information and complete these prerequisites in this order.
See:
"Preparing for Service" on page 43
■
"SAS Drive Configuration" on page 86
■
"Remove the Filter" on page 79
■
Push the release button of the drive.
3.
The release lever pops out.
92 Netra SPARC S7-2 Server Service Manual • February 2017
"Remove a SAS Drive" on page
Step 3.
Step 3.
89.
Step 2.