Power On An Nvme Drive And Attach A Device Driver - Oracle Netra SPARC S7-2 Service Manual

3. Consider your next step.
If adding a drive to an empty slot, remove the drive filler.
■
If replacing a faulty NVMe drive, remove the drive.
■
See "Remove an NVMe Drive" on page
Align the new drive with the drive slot.
4.
The drive is physically addressed according to the slot in which it is installed. You must install a
replacement drive in the same slot as the drive that was removed.
Slide the drive into the slot until the drive is fully seated.
5.
6. Rotate the air filter up until the latches click.
See "Install the Filter" on page
7. Close the drive latch to lock the drive in place.
Power on the drive and attach a device driver.
8.
See "Power On an NVMe Drive and Attach a Device Driver" on page
Related Information
"Power On an NVMe Drive and Attach a Device Driver" on page 101
■
"Verify the Operation of an NVMe Storage Drive" on page 102
■

Power On an NVMe Drive and Attach a Device Driver

This task uses pcie13 as an example.
1. Enable the drive slot.
# hotplug enable pciex
where x is the slot number. See
2. Display the status of the NVMe drive.
The state of the slot must be Enabled.
Note -
# hotplug list –lc
Power On an NVMe Drive and Attach a Device Driver
99.
82.
"Device Paths" on page
101.
20.
Servicing NVMe Storage Drives 101