Install The Drive Power Cable - Oracle Netra SPARC S7-2 Service Manual

Install the Drive Power Cable

"Returning a Server to Operation" on page 235
■
Install the Drive Power Cable
Installing a cable is a cold-service operation. You must power off the server before installing the
cable.
1. Connect the cable to the motherboard.
Route the cable into the cable clamp and against the server wall.
2.
If you removed the fan modules and tray, complete these prerequisites in this
3.
order.
See:
"Install the Fan Tray" on page 244
■
"Install a Fan Module" on page 155
■
Install all fan modules.
202 Netra SPARC S7-2 Server Service Manual • February 2017