See
"Verify the Drive Backplane" on page
Related Information
"Internal Component Locations" on page 16
■
"Remove the Drive Backplane" on page 165
■
Verify the Drive Backplane
1.
Use the Oracle ILOM show faulty command to verify that the fault has been
cleared.
See
"Identify Faulted Components" on page 24
command.
2.
Perform one of the following tasks based on your verification results:
If the previous steps did not clear the fault, see
■
Faults" on page 23
to diagnose component faults.
If the previous steps indicate that no faults have been detected, then the
■
component has been replaced successfully. No further action is required.
Related Information
"Remove the Drive Backplane" on page 165
■
"Install the Drive Backplane" on page 168
■
171.
for more information on using the show faulty
for information about the tools and methods you can use
Verify the Drive Backplane
"Detecting and Managing
Servicing the Drive Backplane
171