Identify Faulted Components - Oracle Netra SPARC S7-2 Service Manual

Identify Faulted Components

You can use LEDs and software to identify faulty components, however, it is best to rely on
software to determine if a component is faulty.
The fmadm faulty command displays the list of faults detected by PSH. You can run this
command from the host or through the Oracle ILOM fault management shell.
Identify fault LEDs.
1.
See "Identifying Components" on page
2.
From the Oracle ILOM prompt, start the fault management shell and type fmadm
faulty.
This example shows how to check for faults through the Oracle ILOM fault management shell.
You can also check for faults by typing this command at the Oracle ILOM prompt.
-> start /SP/faultmgmt/shell
Are you sure you want to start /SP/faultmgmt/shell (y/n)? y
faultmgmtsp> fmadm faulty
----------------------------------------------------------------------------
Time
----------------------------------------------------------------------------
2016-05-02/19:54:29 2782ad0c-91cb-c780-9663-807f0bf806df SPSUN4V-8001-0J MAJOR
Problem Status : open
Diag Engine : fdd 1.0
System
Manufacturer : Oracle Corporation
Name : SPARC S7-2
Part_Number : 9999991201
Serial_Number : 4568BDC0DF
----------------------------------------
Suspect 1 of 1
Fault class : fault.io.pciex.bus-linkerr-deg
Certainty : 100%
Affects : /SYS/MB/PCIE_SWITCH1/PCIE_LINK14
Status : faulted
FRU
Status : faulty
Location : /SYS/MB
Manufacturer
Name
13.
UUID
: Oracle Corporation
: TLA,MB,TRAY,S7-2
Identify Faulted Components
msgid Severity
Detecting and Managing Faults 27