Locate An Eusb Drive; Determine If An Eusb Drive Is Faulty - Oracle Netra SPARC S7-2 Service Manual

Locate an eUSB Drive

Locate an eUSB Drive
From the OpenBoot PROM, type:
okprobe-scsi-all
.../pci@300/pci@1/pci@0/pci@2/usb@0/storage@1Unit...0...Disk...smiMICRON...eUSB.DISK...
1112
...
Related Information
"Determine if an eUSB Drive is Faulty" on page 104
■
"Identifying Components" on page 13
■
"Install the eUSB Drive" on page 106
■
"Remove the eUSB Drive" on page 105
■

Determine if an eUSB Drive is Faulty

1. Check to see if any Server Service Required LEDs are lit or flashing.
See "Front Panel Components (Service)" on page 17
2. In Oracle ILOM, verify that the eUSB drive is recognized and check the
fault_state.
->show/SYS/MB/EUSB_DISK/
./SYS/MB/EUSB_DISK
....Targets:
....Properties:
....type.=.Flash.Mini-Disk
....fault_state.=.OK
....clear_fault_action.=.none)
....Commands:
....cd
....set
....show
...
->
3.
Use the Oracle ILOM faultmgmt shell or the fmadm faulty command to identify a
faulty component.
104 Netra SPARC S7-2 Server Service Manual • February 2017
and "Interpreting LEDs" on page 30.