Alcatel-Lucent 7750 SR OS Service Manual page 1016

VPRN Service Configuration Commands
scheduler stops offering bandwidth to member queues once it has detected that the aggregate rate
limit has been reached.
If a port scheduler is not defined on the egress port, the queues are allowed to operate based on their
own bandwidth parameters.
The no form of the command removes the aggregate rate limit from the SAP or multi-service site.
Parameters
agg-rate — defines the rate, in kilobits-per-second, that the maximum aggregate rate that the queues
filter
Syntax filter ip ip-filter-id
no filter
Context
config>service>vprn>if>sap>egress
config>service>vprn>if>sap>ingress
config>service>vprn>sub-if>grp-if>sap>egress
Description
This command associates an IP filter policy with an ingress or egress Service Access Point (SAP) or
IP interface.
Filter policies control the forwarding and dropping of packets based on IP matching criteria.
The filter command is used to associate a filter policy with a specified ip-filter-id with an ingress or
egress SAP. The ip-filter-id must already be defined before the filter command is executed. If the
filter policy does not exist, the operation will fail and an error message returned.
In general, filters applied to SAPs (ingress or egress) apply to all packets on the SAP. One exception
is non-IP packets are not applied to IP match criteria, so the default action in the filter policy applies
to these packets.
The no form of this command removes any configured filter ID association with the SAP or IP
interface. The filter ID itself is not removed from the system unless the scope of the created filter is
set to local. To avoid deletion of the filter ID and only break the association with the service object,
use scope command within the filter definition to change the scope to local or global. The default
scope of a filter is local.
Parameters
ip ip-filter-id — Specifies IP filter policy. The filter ID must already exist within the created IP filters.
match-qinq-dot1p
Syntax match-qinq-dot1p {top | bottom}
no match-qinq-dot1p
Context config>service>vprn>if>sap>ingress
config>service>vprn>sub-if>grp-if>sap>ingress
Description
This command specifies which Dot1Q tag position Dot1P bits in a QinQ encapsulated packet should
be used to evaluate Dot1P QoS classification.
Page 1016
on the SAP or multi-service site can operate.
Values
1 — 40000000, max
Values
1 — 65535
7750 SR OS Services Guide