Alcatel-Lucent 7750 SR OS Service Manual page 568

VPLS Service Configuration Commands
sdp-using
Syntax sdp-using [sdp-id[:vc-id] | far-end ip-address]
Context show>service
Description
Display services using SDP or far-end address options.
Page 568
Label
The administrative state of this SDP.
Admin State
The operational state of this SDP.
Oper State
The label used by the far-end device to send packets to this device in this
Ingress Label
service by this SDP.
The label used by this device to send packets to the far-end device in this
Egress Label
service by the SDP.
Last Changed The date and time of the most recent change to the SDP.
Specifies the signaling protocol used to obtain the ingress and egress labels
Signaling
used in frames transmitted and received on this SDP.
The administrative state of the Keepalive process.
Admin State
Oper State The operational state of the Keepalive process.
Specifies how often the SDP Echo Request messages are transmitted on
Hello Time
this SDP.
Specifies the maximum number of consecutive SDP Echo Request
Max Drop Count
messages that can be unacknowledged before the keepalive protocol reports
a fault.
Specifies the length of the SDP Echo Request messages transmitted on this
Hello Msg Len
SDP.
Specifies the amount of time to wait before the keepalive operating status is
Hold Down Time
eligible to enter the alive state.
Specifies the number of forwarded ingress packets.
I. Fwd. Pkts.
Specifies the number of dropped ingress packets.
I. Dro. Pkts
Specifies the number of forwarded egress packets.
E. Fwd. Pkts.
E. Fwd. Octets Specifies the number of forwarded egress octets.
When the SDP type is MPLS, a list of LSPs used to reach the far-end router
Associated LSP
List
displays. All the LSPs in the list must terminate at the IP address specified
in the Far End field.
If the SDP type is GRE, then the following message displays:
SDP Delivery Mechanism is not MPLS
Description (Continued)
7750 SR OS Services Guide