Alcatel-Lucent 7750 SR OS Service Manual page 748

IES Service Configuration Commands
interfaces a GI address must be specified under the group interface DHCP context or subscriber-
interface DHCP context in order for DHCP to function.
Default
no gi-address
Parameters
ip-address — Specifies the host IP address to be used for DHCP relay packets.
src-ip-address — Specifies that this GI address is to be the source IP address for DHCP relay packets.
lease-populate
Syntax lease-populate [number-of-entries]
no lease-populate
Context config>service>ies>if>dhcp
config>service>ies>sub-if>grp-if>dhcp
Description
This command enables dynamic host lease state management for IES IP interfaces. Lease state
information is extracted from snooped or relayed DHCP ACK messages to populate lease state table
entries for the IP interface.
If lease state population is enabled and an entry cannot be added to the table, the system will prevent
the far-end host from receiving the DHCP ACK message.
The retained lease state information representing dynamic hosts may be used to populate a SAP based
anti-spoof filter table to provide dynamic anti-spoof filtering and/or ARP cache population.
Default
ies>if>dhcp: no lease-populate
ies>sub-if>grp-if>dhcp: 1
Parameters
number-of-entries — This optional parameter defines the number of lease state table entries allowed
for this IP interface. If number-of-entries is not specified, only a single entry is allowed. Once the
maximum number of entries has been reached, subsequent lease state entries are not allowed.
Page 748 7750 SR OS Services Guide