Configuring Saa Test Parameters - Alcatel-Lucent 7750 SR OS Service Manual

Configuring SAA Test Parameters

Use the following CLI syntax to create SAA test parameters:
Example
The following example displays the configuration:
A:ALA-48>config>saa# info
----------------------------------------------
----------------------------------------------
A:ALA-48>config>saa#
After running the test twice, the result is displayed below:
A:ALA-48>config>saa# show saa t1
Test Run: 1
Total number of attempts: 5
Number of requests that failed to be sent out: 1
Number of responses that were received: 4
Number of requests that did not receive any response: 0
Total number of failures: 1, Percentage: 20
Roundtrip Min: 0 ms, Max: 30 ms, Average: 15 ms, Jitter: 1 ms
Per test packet:
Sequence: 1, Result: The active lsp-id is not found., Roundtrip: 0 ms
Sequence: 2, Result: Response Received, Roundtrip: 0 ms
Sequence: 3, Result: Response Received, Roundtrip: 0 ms
Sequence: 4, Result: Response Received, Roundtrip: 30 ms
Sequence: 5, Result: Response Received, Roundtrip: 30 ms
Test Run: 2
Total number of attempts: 5
Number of requests that failed to be sent out: 0
Number of responses that were received: 5
Number of requests that did not receive any response: 0
Total number of failures: 0, Percentage: 0
Roundtrip Min: 0 ms, Max: 40 ms, Average: 14 ms, Jitter: 5 ms
Per test packet:
Sequence: 1, Result: Response Received, Roundtrip: 40 ms
Sequence: 2, Result: Response Received, Roundtrip: 0 ms
Sequence: 3, Result: Response Received, Roundtrip: 0 ms
Sequence: 4, Result: Response Received, Roundtrip: 0 ms
Sequence: 5, Result: Response Received, Roundtrip: 30 ms
7750 SR OS Services Guide
:config# saa
config>saa# test t1
config>saa>test$ type
config>saa>test>type$ lsp-ping to-104 interval 4 send-count 5
config>saa>test>type$ exit
config>saa>test# no shutdown
config>saa>test# exit
config>saa# exit
test "t1"
type
lsp-ping "to-104" interval 4 send-count 5
exit
no shutdown
exit
OAM and SAA
Page 1387