Alcatel-Lucent 7750 SR OS Service Manual page 1432

OAM and SAA Command Reference
Parameters
ip-address — The far-end IP address to which to send the svc-ping request message in dotted decimal
dns-name — The DNS name of the far-end device to which to send the svc-ping request message,
ttl time-to-live — The TTL value for the MPLS label, expressed as a decimal integer.
wait milliseconds — The time in milliseconds to wait for a response to a probe, expressed as a
tos type-of-service — Specifies the service type.
source ip-address — Specifies the IP address to be used.
router router-instance — Specifies the router name or service ID.
lsp-ping
Syntax lsp-ping {{[lsp-name] [path path-name]} | {prefix ip-prefix/mask}} [fc fc-name] [profile {in |
out}]] [size octets] [ttl label-ttl] [send-count send-count] [timeout timeout] [interval
interval] [path-destination ip-address] [interface if-name | next-hop ip-address]][detail]
Context oam>
config>saa>test>type
Description
Performs in-band LSP connectivity tests.
The lsp-ping command performs an LSP ping using the protocol and data structures defined in the
RFC 4379, Detecting Multi-Protocol Label Switched (MPLS) Data Plane Failures.
The LSP ping operation is modeled after the IP ping utility which uses ICMP echo request and reply
packets to determine IP connectivity.
Page 1434
notation.
Values
ipv4-address:
ipv6-address:
expressed as a character string to 63 characters maximum.
Values
1 — 255
decimal integer.
Default
5000
Values
1 — 60000
Values
0 — 255
Values
ipv4-address:
ipv6-address:
Values
router-name:
service-id:
Default
Base
a.b.c.d
x:x:x:x:x:x:x:x
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
a.b.c.d
x:x:x:x:x:x:x:x
x:x:x:x:x:x:d.d.d.d
x: [0 — FFFF]H
d: [0 — 255]D
Base , management
1 — 2147483647
7750 SR OS Services Guide